Experimental Laboratory II - PHY00009I

« Back to module search

  • Department: Physics
  • Module co-ordinator: Prof. Kevin O'Grady
  • Credit value: 20 credits
  • Credit level: I
  • Academic year of delivery: 2019-20

Related modules

Pre-requisite modules

  • None

Co-requisite modules

  • None

Module will run

Occurrence Teaching cycle
A Autumn Term 2019-20 to Summer Term 2019-20

Module aims

The second year experimental laboratory builds on the knowledge gained in the 1st year lectures and the skills learned in the first year laboratory. The 2nd year laboratory aims to increase the level of sophistication in the experiments, approach to data analysis, and laboratory report writing. There is emphasis on the use of and critical evaluation of modern (computer-based) instrumentation. The laboratory is organised on a zoned (thematic) basis and LabView software is taught formally in one of the zones occupying 20% of the laboratory. A further zone (20%) is Electronics. The other zones each constitute 20% of the course and are focused on: General Physics, Optics, Atomic and Nuclear Physics, and Electromagnetism and Solid State Physics. The remainder of the laboratory has a balance (50%:50%) of experiments designed to support formal lecture teaching and new topics.

Module learning outcomes

Demonstrate good experimental practice including appropriate awareness of safety

Demonstrate quality of record keeping.

Be able to plan and execute experiments over an extended time

Be able to demonstrate critical assessment of your measurements and results

Be able to identify and assess errors

Critically discuss your experimental results

Have developed further skills in a range of experimental techniques and in the operation of equipment and appropriate data analysis and processing software beyond that in the 1st year laboratory.

Be able to communicate and present your experimental work in the format of a leading scientific journal.

Demonstrate the ability to use LabView software for interfacing equipment to a computer.

Module content

Students should taken either PHY00012C, PHY00013C or PHY00014C as prerequisites. 

Assessment

Task Length % of module mark
Essay/coursework
Lab notebook
N/A 56
Essay/coursework
Report 1 (Term 1)
N/A 22
Essay/coursework
Report 2 (Term 2)
N/A 22

Special assessment rules

Non-compensatable

Reassessment

Task Length % of module mark
Essay/coursework
Lab notebook Re-assessment
N/A 50
Essay/coursework
Report Re-assessment
N/A 50

Module feedback

Laboratory books - Your laboratory note book will be marked, and annotated, by your demonstrator. You will get verbal feedback on your work at this time.

Formal reports - You will receive your report back along with a mark sheet that provides a mark and a set of comments/suggestions for each section of the report. Following the first term report, you will receive feedback (as a group) during Term 2 to guide you in the preparation of the second report. Individual verbal feedback on formal reports will be provided if requested (see the Laboratory Coordinator for this).

Indicative reading

Laboratory Scripts - Lab Scripts will be provided



The information on this page is indicative of the module that is currently on offer. The University is constantly exploring ways to enhance and improve its degree programmes and therefore reserves the right to make variations to the content and method of delivery of modules, and to discontinue modules, if such action is reasonably considered to be necessary by the University. Where appropriate, the University will notify and consult with affected students in advance about any changes that are required in line with the University's policy on the Approval of Modifications to Existing Taught Programmes of Study.